-
-
Slide 2 - Balance Support AdjustmentsCraig demonstrates the importance of a properly adjusted Balance Support.
-
Slide 3 - Handle AdjustmentsCraig shows several handle locations in order to acheive balanced pressure.
-
Slide 4 - Handle AdjustmentsKen shows the advantage of securing the handle in a skewed position.
-
Slide 5 - Cleaning the Non-Slip PadsCraig & Ken show two simple ways to keep the surface of the Non-Slip Pads clean and working effectively.
-
Slide 6 - Leapfrogging Technique for Long StockCraig & Ken demonstrate the "leapfrogging" technique with two GRR-RippersĀ® when ripping long boards.
-
Slide 7 - Adding a Trailing HookA simple small scrap block can be added to the rear slot of the GRR-Ripper for feeding uneven surfaced or slippery surfaced material. Extremely easy to make, it takes seconds to install or remove.
-
Slide 8 - New Product - ZeroPlay Guide Bar SystemUnlike using contact points that require trial and error screw adjustments, the ZeroPlay Guide Bar is a shorter version of the typical miter jig bar for sleds and shop jigs. A single forward push automatically expands it to exact width for a custom fit to your machine, contacting both side walls of the miter slot for a PERFECT fit.
-
Slide 9 - New Product - MJ Tapering JigCraig cuts a taper using the jig and two GRR-Ripper GR-200s - more product details to follow.
-
Slide 10 - New Product - MJ Splitter for ZCIKen creates an alignment saw kerf on the set-up board.
-
Slide 11 - New Product - MJ Splitter for ZCIThe Drill Guide is attached to the alignment saw kerf, enabling Ken to precisely drill the splitter location holes on the ZCI.
-
Slide 12 - New Product - MJ Splitter for ZCIThe MJ Splitter is installed by plugging it into the drilled location holes - perfectly aligned behind the saw blade!
