-
Slide 1One D/C is used as a chip deflector and blade cover on a single GRR-Ripper operation on table saw. This setup can also be used with the leapfrog technique, but do not lift off the GRR-Ripper with the D/C attached in this position at an excessive angle.
-
Slide 2For feeding longer stock, use one D/C to connects two GRR-Rippers® fore and aft, while a second D/C serves as a deflector.
IMPORTANT: An out-feed table is necessary with this configuration. Micro Jig recommends using the MJ Splitter during this operation.
-
-
Slide 4Cut as wide as 13-3/4” with saw blade passing through a GRR-Ripper tunnel.
-
-
Slide 6Use the D/C as a chip deflector when pattern routing.
