Micro Jig

It is a control system for the table saw that feeds both sides of your stock without using your bare hands.

It is a precision system that rips as narrow as 1/4" (6.35mm) with balanced pressures to prevent burning and kick back at all times.

It is a hold down that replaces multiple feather boards during use.

It is a splitter that keeps both sides of your stock absolutely parallel to saw blade (regardless of changing between any thickness of saw kerfs) throughout the entire cutting process.

It is a safety guard – the saw blade passes through a “tunnel." It is a blade guard that the user holds, rather than a blade guard that is affixed to the back of the table saw, or one that hovers above it.

It is a tool (Model GR-200) that can be customized for edge jointing on the table saw with a perfect straight edge in one single pass.

It is a tool that can be configured for resawing on the table saw for narrow stock with repeatable accuracy without sanding.

It is a tool (Model GR-200) that can be customized for repeated cross-cutting of small pieces on the table saw without fence/stop adjustment.

Use it as a custom jig for router bits that do not have a pilot bearing (such as a bull nose bit) to obtain the full profile without snipe.

Use it as a custom jig for router bits that do not have a pilot bearing (such as a bull nose bit) to obtain the full profile without snipe.

Use it as a navigator to contour irregularly-shaped pieces when pattern routing.

The elimination of bare-hand feeding makes it the safest tool for manual feeding, with total protection for ALL of your fingers.

Fully customizable for different cutting requirements.

Go Back to GRR-Ripper Page