Micro Jig

The 1/8” Leg is designed to rip as narrow 1/8” with the GRR-Ripper. The 1/8” Leg has ½” height clearance for the saw blade to pass. Make sure that the saw blade is at most ½” above the surface of the stock.

On the outside surface of the 1/8” Leg there is a line outlining the maximum blade height. We recommend highlighting this line with a permanent marker.

Highlight all five notches.

Make sure the saw blade does not exceed the maximum blade height guideline. With the 1/8” Leg, you will cut with unprecedented accuracy and precision.

Go back to the 1/8" Leg.