MJ Deflector/Connector
 

 

New Accessory for the GRR-Ripper® (Year 2006)

MJ Deflector/Connector

Package Contents

The MJ Deflector/Connector is constructed of thick see-through polycarbonate with a handy Built-in Magnifier (for inspecting saw blade tips and other cutting tools).  The Deflector/Connector can be securely fastened or adjusted for snap-on fit with the included thumbscrews.

 


The green thumbscrews are not shown.

The MJ Deflector/Connector (D/C) is designed to enhance the user experience of the GRR-Ripper® System. The D/C can be used for chip/dust deflection. It can also serve as a connecting bridge between two GRR-Rippers®, where it allows for multiple configurations when used on the table saw, router table, and shaper. When the D/C is installed behind a GRR-Ripper®, it also serves as a blade cover when exiting the cut on the table saw.

Note: The MJ Handle Bridge Set (Model # GRHB-010) must be installed on your GRR-Ripper® (Model # GR-100 or GR-200) prior to installing the MJ D/C.  Click here to see the MJ Handle Bridge Set.
 


 

One D/C is used as a chip deflector and blade cover on a single GRR-Ripper® operation on table saw. This setup can also be used with the leap-frogging technique, but do not lift off the GRR-Ripper® with the D/C attached in this position at an excessive angle.
 


 

One D/C connects two GRR-Rippers® fore and aft, while a second D/C serves as a deflector. An out-feed table is necessary with this configuration! Use of the MJ Splitter is recommended with this setup.


 

One D/C connects two GRR-Rippers® for wider cuts.


 

Cut as wide as 13-3/4” with saw blade through tunnel.


 

Another way to connect two GRR-Rippers® with a different width than those shown in above.


 

One D/C used as a chip deflector when pattern routing.

 

 

Review


 

Click on the picture to see the review by Bill Esposito.

Note: The MJ Handle Bridge Set (Model # GRHB-010) must be installed on your GRR-Ripper® (Model # GR-100 or GR-200) prior to installing the MJ Deflector/Connector. 
Click here to see the MJ Handle Bridge Set.

 

MJ Deflector/Connector (Model GRDC-020)      Sale - $12.95
For existing GRR-Ripper® System previously equipped with the MJ Handle Bridge Set

 
MJ Deflector/Connector with MJ Handle Bridge Set  (Model GRDV-030)   Sale - $22.95

Click here for the Price / Order form or call (407) 696-6695 to order

Click here to download or print the MJ Deflector/Connector Installation Manual

PDF File (1.45MB)

 

 

[ Home ] [ GRR-Ripper ] [ GRR-Ripper DVD ] [ MJ Handle Bridge ] [ MJ Deflector/Connector ] [ MJ Splitter ] [ Thin Kerf MJ Splitter ] [ Products Reviews ] [ Testimonials ] [ Innovative Uses ] [ All Animations ] [ Where To Buy ] [ Price / Order ] [ Woodworking Shows ] [ Assembly ] [ Links ] [ Contact Us ]

Send mail to microjig@gmail.com with questions or comments about this web site.
Copyright © 2007 Micro Jig, Inc.
Last modified: 03/26/07