MatchFIt : Dovetail Track System
CNC Kit + FREE Dovetail Router Bit
Experience the unmatched innovation of the MatchFit CNC Workholding Kit, where the ingenious low-profile design elevates your woodworking without getting in the way of your tools. It is the only clamping system that uses the MatchFit Dovetail System to securely hold stock while you work the top on your CNC, clamping table, jig, or fixture. Specially designed to route tracks for MatchFit Dovetail Clamps and Dovetail Hardware. The Dovetail Bit's built-in roundovers cut clean dovetail grooves in a single pass. Less time sanding, more time building.
MATCHFIT : Dovetail Track System
Buy 2 Ratchet Clamp APs + FREE Pop Stop (6-pack)
Most clamp arms are free to fall down when released forcing you to reset them every time you secure them, but not the MatchFit Ratchet Clamp AP. The exclusive “Anti-Pivot” AP Spring holds the arm where you set it. Now you can release the pressure, move your stock, and reclamp without needing to adjust the arm, upside down or right side up.
Set Pop Stops anywhere in your dovetail grooves. They stay above the surface during use and automatically folding into the groove when covered. Buy two Ratchet Clamp APs and get FREE Pop Stops for a limited time!
